MMA Road Marking Paint 5 kg; Constance Road Marking Paint is an MMA Cold Plastic Paint. Constance Road Marking Paint is suitable for interior and exterior use. Constance Marking Paint can be used in indoor applications such as factory floors, warehouses, hospitals and sports halls and outdoors on roads, cycle paths, school playgrounds and car parks etc. It should not be applied on alkyd-based cold road marking paints and damp, wet and frosty surfaces. This single-component paint reflects light thanks to glass beads sprinkled on it. The best way to apply this paint is to spray it with a thickness range of 350 -800 microns. Drying occurs by evaporation of the solvent in paint. Technical Features Application Temperature: 5 °C- 40 °C Maximum Humidity: 80% Drying Time: 20 min. (air temperature 17°C, ground temperature 22°C, 49% humidity, 6 km/h wind) Packaging : 5 kg / Tin Viscosity: 90 ± 10 (23°C±1) Application: with an airless or pneumatic paint sprayer, brush, roller. Use without diluter Surface: Asphalt and concrete Feature: Cold road marking paint with MMA based acrylic resin component. Storage: Store in dry and regularly ventilated indoor areas, keep away from fire. Cleaning: With cellulosic thinner Wet Paint Consumption Amount: 800 gr / m² Glass Bead Application Amount: 350 gr / m² Colour: Blue, Yellow, Green, Red, White, Black, Orange, Grey. Application: Ensure surfaces are clean, dry and free from any loose material. Remove any contamination, including dust, oil and laitance. New concrete must be allowed to fully cure which can take up to 3 months. In all cases, a small area should be tested before application. Mix thoroughly before use. If the concrete/asphalt is particularly porous, a thinner first coat should be applied to seal the surface. This should then be followed by another coat applied 1-2 hours after the sealer coat. A minimum thickness of 350 microns is recommended. GTIP: 3208.90.91.00.22